How To Use Roof Jacks On A Metal Roof

Remember that most shingles can actually be dilapidated and they can easily break.

How to use roof jacks on a metal roof.

How to use the jacks. Then we need to hook the roof jacks for metal roofs into the nails. Metal is a slippery material especially when it gets wet or covered with snow. Roof jacks for metal roofs.

If there is a significant down side of using metal roof it is the safety aspect when you need to get over it. Once all the jacks are in place place the. Roof jacks provide a stable surface to work increasing safety and making it easier to apply roofing. Drive a nail in each slot and pound it down in such a way that it is level with the metal of the jack.

So you will need to place your jacks at least somewhere in the fourth or fifth shingle course. Now you ve installed the first one. Underneath the roof jacks we only need to insert some nails through the decking and the rafter. You can usually feel sheathing nails which are driven into rafters through the underlayment attach a jack by driving two 16d nails never roofing nails into a rafter.

Two more nails are usually sufficient to hold the jack. In order to use the jacks the first thing to do is to find a flat and clean area in your roof. Make sure that you don t push it all the way inside your roof since you might damage it. You can use the dead area with a jack roof coating so that you can accurately and easily move on top of the roof.

Next drive a nail at the bottom part of the jack in order to secure it on both ends. Ideally locate a rafter below the sheathing. Avoid climbing on the roof when it is on either mentioned condition.