How To Put Up Wood Panel Siding

For an installation over wood frame walls that sit on a concrete or masonry foundation the starter strip should be.

How to put up wood panel siding.

Put the glue on the batten and once that s all done for the whole panel squeeze the panel up against the glue and then use a hammer to secure the pins in place. This is a good idea even if the panels are preprimed because plywood edges are very. Locate stud centers and mark. Installing the siding use a table saw to rip a 1 wide strip of the siding.

Lap siding also called horizontal siding or clapboard may be made of wood fiber cement plywood hardboard or similar materials. Step 1 before the siding is installed take a layer of plywood sheathing covered with felt building paper and install it onto the exterior surface of a your house s wood frame. Step 7 fix moldings in place. Step 2 cutting wood siding.

The felt paper acts as a water and air barrier but allows water vapor to pass through so as not to accumulate in the wall assembly. Trim to fit step 5. Cut openings step 6. How to do it prep the walls.

The starter strip must be installed level and properly spaced from whatever is below it. Read the full how to. Install metal z flashing at the wall tops if the soffit under the roof overhang is not covered. Apply adhesive step 7.

Repeat for all of the panels. In order to keep fixings hidden as much as possible i m going to suggest using glue and pins to fix the panel to the batten. Prepare the walls as you would for other wood sidings by applying building wrap applying self stick.