How To Nail A Tarp To A Roof

Extend the top edge of the tarp over the ridge of the roof.

How to nail a tarp to a roof.

Screw through the tarp and the boards into the roof with a drill. If you have a helper this part is easy. Screw the 2 by 4 directly into the roof to secure it. Climb on top of the.

Choose 6 equally spaced spots on each 2x4 board. Find the source of the leak. Installing tarp on a roof without nails 1. Sandwich the tarp by nailing a second 2 x 4 board to.

If you have it cover the nail heads with roofing cement to keep it watertight. Unfold the tarp on the roof. Try to pick a day that is not windy or else you may face frustration. Make sure the screw goes through the tarp then the wooden board and into the roof.

Roll the tarp over the damaged area taking care that it extends at least 3 on all sides. It probably goes without saying but the size of the damage also. Don t forget to secure the strapping used in step 4. Then fold the excess tarp under a few rotations for a tight clean fit.

It makes sense to get most of the pieces of wood up on the roof beforehand. Pull the tarp tight and smooth out wrinkles. Next on the peak side attach the tarp to the 2 by 4 using cap nails. Stretch a tarp flat on the roof.

Partially unroll your tarp to cover the damaged area from the roof s eaves to peak. Place the plywood or sheet metal over the hole and use roofing nails and a hammer or decking screws and a cordless drill to secure the plywood to the roof. When you can t reach it and the roof is dry and sturdy climb onto the roof until you can reach the edge of the tarp and wrap it around the plank. There should be an additional 4 feet.

Positions several 1 2 pieces of lumber on the tarp running vertically down the slope of the roof. Measure the dimensions of the tarp to be used. Then with a drill screw in 2 inches 5 1 cm long screws. Install a blue tarp on a roof.

Find the source of the roof leak. Attach the 1x2s through the tarp and into. Wrap the other edge of the tarp around the plank. The 2 by 4 should be about 2 feet longer than the tarp width.

You need to know first which spot on the roof needs tarping up. Create an anchor board by rolling the tarp s peak end with a 2 x 4 inch board and nailing the tarp to your board with. Nail the tarp to the fascia board over the edge of the roof or along the ridge.