How To Install Vinyl Siding Last Row

Vinyl siding installation is designed to hang loosely on the sheathing so that it can expand and contract with temperature changes.

How to install vinyl siding last row.

To stiffen the trimmed section slide a length of utility trim. Push the top of the vinyl siding with the tabs into the utility trim just enough to hold the edge and push the bottom against the second to last piece of siding. Score the vinyl siding at the mark and break off the excess top by. Be sure to check both sides for proper fit.

To prevent the relatively thin panels from buckling observe these fitting and nailing rules. Drop siding panel into j channel around top of window and install. Measure and cut panel in the same manner detailed in step 14 but cut lower portion instead of top. Be sure the top and bottom click into place.

Measure and cut panel to fit. Once it is in place test by sliding the last piece back and forth slightly. The bottom of the starter strip the part the bottom panel hooks on to should be at least 1 in. Using a piece of scrap siding as a template measure the width of the second to last row marking it with your pencil.

Push up gently until you hear a click. Use this template. The siding slides behind vinyl siding trim pieces that hide the gap and the cut end. If you have to cut the last row of siding you ll.

But if the result is not a whole number you will need to cut the final piece of siding lengthwise in order to fill in. If the result is a whole number you re in. Install j channels at doors and windows and under roof eaves and rakes. It protects the sheathing from rain snow and pests.

Gap at all ends. Finishing top row of siding under eaves. Mark the length of vinyl where the cut needs to be made to achieve the correct fit. You must leave the bottom.

How to install the top row of vinyl siding step 1. Measure the gap remaining at the top of the wall. Use the wider starter strip. How do i put up a top piece of vinyl siding.

Then notch the next piece to fit. Below the top of the foundation but the lower the vinyl siding is installed the better. With the insulation backing in place install siding to within one row of the bottom of the window. Install the tops first then the sides and then the bottoms of the window surrounds.

Install siding as normal until you reach the second row from the top.